The Inertia Wave® SOLO + Wall Anchor Kit is the perfect choice to get you going quickly and easily. We take the guess work out of anchoring and provide a perfectly spaced anchoring board that installs in less than 5 minutes. All you need is a drill - the rest is included, even the Inertia Wave!
Wall Anchor dimensions: 35 x 7 x 7
No, the Door Anchors are designed to handle stress being as locked into place as possible. If you use the Door Anchors on doors that do not have hinges, you may destroy the Door Anchor or damage your door.
The proper way to anchor using the Rail Anchors is to keep it flat, wrap it tightly around an object, and feed the D-ring through the opening loop of the nylon strap and pull it tightly three times. Make this connection as snug as you can to the point where the strap cannot slide up or down as you utilize the Inertia Wave. Attach the carabiner to the D-ring of the Rail Anchor, and the O-ring of the tube. Make sure the carabiner is completely closed before use. Do NOT attach the Rail Anchors to any sharp or jagged objects. Be sure to use as much of the Rail Anchors as possible - do not shorten or modify (see above).
As shown in the "Creative Ways to Anchor the Inertia Wave" video, the anchor points should be a minimum of 36-40 inches from ground at waist height, and between 24-36 inches apart. Please remember to always use your Rail Anchors.
These features are part of the Rail Anchor and are used securely anchor the Inertia Wave. The combination of these components help to alleviate the stress, wear, and torque on the anchored end of the Inertia Wave by creating a "stress curve". For best results and a longer lasting Inertia Wave, you MUST keep the Rail Anchors as extended as possible - do not wrap the Rail Anchors around objects repeatedly to shorten its length. The longer the strap, the less strain on the O-ring and tubes.
Yes! If you omit the Rail Anchors to make up for space, you will lose energy in the tubes and weaken the O-ring. If you hook the carabiner directly to your anchor location it will tear on the O-ring and your product will not last. Your Inertia Wave will perform at 100% and last twice as long with the Rail Anchor, carabiner, and O-ring. Note: The carabiner always sits in between the D-ring of the Rail Anchor, and the O-ring of the Inertia Wave.
Yes! The Inertia Wave will not work properly if you decide to omit the Rail Anchor and clip the carabiner to anything else. Use at your own risk when modifying the Inertia Wave.
We recommend, for your safety, never pulling or stretching the Inertia Wave longer than 26 inches. It’s not a bungee and it may lose its integrity if you use it like a resistance tube.
A clearing of 4 feet from left or right- then put your 1st anchor- 2nd anchor 24-36 inches apart YOUR CHOICE. Then SKIP 4 feet - drill or screw in the next anchor…repeat this sequence.
From the anchor point to your hands, you will need at least 11.5 feet in length.
For some of the methods of use, you will need at least 4 feet in width to your left, and 4 feet in width to your right.
For some of the methods of use, you will need at least 7 feet in height from the ground.